![]() The Pioneer Platform is an aerodynamic, reinforced nylon and aluminum load-carrying solution engineered to fit directly onto Rhino-Rack Vortex roof racks or Toyota OEM Crossbars. Cross Bar Assembly RequiredWith Roof Rails Removed Read more Read more compatibility notes Read less Read less compatibility notesĤ.0L 3956CC 241Cu. TheYotaGarage is proud to offer the Rhino-Rack Pioneer Platform 58'x46' for your 2010-2023 Toyota 4Runner. TRD Off-Road Premium Sport Utility 4-DoorĪddl Note = Incl. Cross Bar Assembly Required Read more Read more compatibility notes Read less Read less compatibility notesĤ.0L 3956CC 241Cu. The Rhino-Rack Pioneer and Backbone system is a great accessory so if you are okay with that modification then I totally recommend this product. I ordered everything missing from Rhino Rack, so if anyone wants a good deal on a new platform (no backbone), check the classsifieds for my listing.This part is compatible with 51 vehicle(s) NotesĪddl Note = Incl. In order to install the Rhino-Rack Pioneer Platform Rack with Backbone Mounting System RR79QX on your 2022 Toyota 4Runner TRD you will need to remove the factory rails that are on your roof. A ratcheting wrench is your friend, not even enough clearance for a socket.Īnd now that it’s successfully installed, I’ve got a factory rack (sans center feet) available if anyone in New England needs one.Īlso, I ended up with a second rack from Amazon when the first arrived late and missing parts. VERY little clearance underneath, and it takes some contortion to get the center mounts engaged and tightened down. Had to cut the plastic and use vise grips to turn the bolts as others have.Īs far as the install goes, my only advice would be to keep the center cam lock bolts as loose as possible when setting the rack on the backbone. Finished destroying the factory center feet when I found they had been holding water and the bolts were rusted away. I had the center feet without the flip out panel, so I dinged them up a bit trying to open and expose the mounting bolts. Taking the factory rack off my 2000 was made difficult by the fact that I was following Rhino Rack’s directions for removal instead of the thread on Mud. With the rear hatch open, I have an inch or two of clearance between the spoiler and the rack.Īdded a Pioneer platform on the backbone system this week. I didn’t want to remove the spoiler so I measured out the spacing and drilled new mounting holes in the platform. Swapping the channels to run left to right takes all of 5 minutes. While not in use, the channels are mounted on the outer edges and create a “flush mounted roof rail” so to speak. I’m hoping that it will work with a Yakima Sky Rise RTT but that’s yet to be seen. I also got some of the 1220mm c-channel for mounting up the Thule ski box. If it ends up being to close to the truck, I can remove the required 5mm spacers and install some thicker ones as they make 5mm, 10mm, 15mm, 20mm, and 25mm spacers. I wanted the rack to be as close to the truck as possible so I went with the RCL feet which is 15mm lower than the recommended RCH feet. Turns out the it isn’t really an issue, just that the feet don’t fit into the base fit kit quite like I would hope. I thought I had some issues with the feet and Rhino Rack customer service has been great with getting it sorted. Single person installation No measuring required Specifically designed to be used with the 5th GEN. Overall, I’m super pleased with the setup and I’d definitely go the same route if I was to do it again. Rhino-Rack Pioneer System to be fitted on top. I finally got around to ordering a 76” x 54” Pioneer platform just before they shut down for the covid-19 fiasco.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |